From: Martin S. <ma...@li...> - 2009-07-31 16:27:56
|
>>>>> On Thu, 30 Jul 2009 15:23:33 -0400, teksupptom said: > > Greetings! > > I've been working on adding automated Verify jobs to my configuration. I'd > like to abuse my tape drive as little as possible, so I have the backups set > to run as a group, then the verifies set to run at a later time as a group. > > On a normal weeknight (like tonight), I have two Incremental jobs for each > client, backing up two different FileSets. The Scheduled queue in the > Director status for tonight shows my normal Incremental jobs, apparently > sorted by client, starting with the last client in the config file and going > backwards to the first client. These jobs are set to start at the same time. > > After this section I see the Verify jobs listed. The odd thing is that the > list begins with the verify for one fileset only, listing that job from the > first client in the configuration file to the last, and then lists the other > verify job from the last client to the first. This will cause a ton of tape > movement. > > What I was hoping to see would be that the backups would proceed as normal, > both jobs for each client, then the verify jobs would follow the same > pattern, so that the tape used would only need to rewind and move forward > one time. I think they are considered in the order that the Job definitions appear in the bacula-dir.conf. To guarantee the order, it is best to use different priorities. I use priorities 1, 2, 3 etc for the backups and 201, 202, 203 etc for the corresponding verifies. __Martin |