Error : Read Property Object list Error (1)

Brought to you by: anders-agren, skarg

Error : Read Property Object list Error (1)

Forum: Help

Creator: Ninh Van The

Created: 2015-05-04

Updated: 2015-05-31

Ninh Van The - 2015-05-04

Good afternoon,
I have a problem and need some helps. I downloaded the project, debug Winsock and also debug Apptest 1. I found out devices on my network and write or read present value ago. But now, i can't understand , i can't get objects agian and Apptest 1 inform "Read Property Object list Error (1)" , Please help me out that!
Thank you so much !

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Paul Pisarchuk - 2015-05-04
  
  I've made quite a few changes to the BACSharp project, but have not had a chance to upload it yet. I'll try to get to it this afternoon/evening. Chances are it'll take care of the error you're seeing.
  
  Paul
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
  - Ninh Van The - 2015-05-25
    
    Hi Paul,
    I have checked your software-update but, i still meet this error ago. I try connect to my device, firstly, the software done when connect and read/write binary output. However, when I close the software and restart it again. I can do that. Apptest inform "Read Property Object list Error (1)".
    
    If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Ninh Van The - 2015-05-07

Hi Paul,
Thank for your reply, I have just downloaded the project and I'll try my device later because i am not in my lab. I believe that it is useful!

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Paul Pisarchuk - 2015-05-26

Run WireShark and capture the packets. Set the filter to UDP 47808. Look to see if the device is responding, and if so, are there packet errors or timeouts.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Ninh Van The - 2015-05-26
  
  I not only use WireShark and I also use OPC Server BACnet , one OPC Client BACnet both they are ok. I can read/write present any object normally.
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Ninh Van The - 2015-05-31

Thank Paul,
I have fixed my error, OPC server for BACnet used port 47808 so AppTest1 not working.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.