Stanislaw - 2014-11-13

I have a problem communicating with Atmega48.
OS Linux Debian Jessie
Eclipce Version: 3.8.1

ATmega32 programmed without any problem

Atmega48
Projekt>Właściwości>AVR>Taget Hardware Load from MCU
window pops:
Could not understand the output from AVRDude.
-Either avrdude returned an error massage that is not covered by the AVR Eclipse Plugin
-or you have a newer AVRDude version with a changed output format.
In either case check yhe AVRDude return massage below and contact the AVR Eclipse Plugin maintainers to have this fixed.
https://sourceforge.net/projekts/avr-eclipse/
Przyczyna:
Could not find a valid Signature in the avrdude output

attempt programming Atmega48, results in the console:

Launching /usr/bin/avrdude -pm48 -cusbasp -PUSB -F
-Uflash:w:BLDC_stary.hex:a
Output:

avrdude: error: programm enable: target doesn't answer. 1
avrdude: initialization failed, rc=-1
avrdude: AVR device initialized and ready to accept instructions
avrdude: Device signature = 0x881611
avrdude: Expected signature for ATmega48 is 1E 92 05
avrdude: NOTE: "flash" memory has been specified, an erase cycle will be
performed
To disable this feature, specify the -D option.

avrdude done. Thank you.

avrdude finished