#2 Joystick input not processed

[Anonymous]

Hi folks,
Let me first thank you briefly for the great job of putting
together all the bits for that helicopter. I was able to
compile version 2.4 of the simulation software. When I
tried to run calibrate using my Saitek joystick pressing
the button a single time allways made the program jump
from the beginning to measuring several axes. It looks to
me as if the program reads the joystick port several
times per second and does report a "pressed" state
every time. I put in a few lines to make the program
stop if the button wasn't released in between. That
worked alright but when I started the simulation the
helicopter would always fall off to the same side
regardless of my joystick movments. Is there anything
else I would have to enable to come to flying the heli?