i´ve also own a Seben EQ EM10 and looking forward to attach a ST-4 to my handcontroller.
How have you connected the RJ6 to the handcontroller ? Have you used the via holes for connecting the ST-4 wires.
I´m also thinking for exchange the motors and replace them with stepper motors and using a motor shield for my Arduino. But first i´m looking forward to use the motors built at the mount.
Thanks for your help,
Bernd
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Bernd, sorry for late reply. Actually the RJ6 connector did not fit very well with the handcontroller so I actually glued the connector on the outside with hot glue. Really ugly but it works. The then cables go inside via a small hole and have the opto couplers inside there.
Last edit: Lars Berntzon 2013-01-23
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello Lars,
i´ve also own a Seben EQ EM10 and looking forward to attach a ST-4 to my handcontroller.
How have you connected the RJ6 to the handcontroller ? Have you used the via holes for connecting the ST-4 wires.
I´m also thinking for exchange the motors and replace them with stepper motors and using a motor shield for my Arduino. But first i´m looking forward to use the motors built at the mount.
Thanks for your help,
Bernd
Hi Bernd, sorry for late reply. Actually the RJ6 connector did not fit very well with the handcontroller so I actually glued the connector on the outside with hot glue. Really ugly but it works. The then cables go inside via a small hole and have the opto couplers inside there.
Last edit: Lars Berntzon 2013-01-23