Re: [Astlinux-devel] Removal of External Failover Destination Routes

[Michael K. <mic...@ip...>]

Agreed.
Also is possible to perform a network restart only e.g. not needing to restart the whole system?

Regards
Michael Knill

On 14/7/19, 12:52 am, "Michael Keuter" <li...@mk...> wrote:

    
    > Am 13.07.2019 um 15:24 schrieb Lonnie Abelbeck <li...@lo...>:
    > 
    > Hi Michael,
    > 
    >> when I add or remove an External Failover Destination Route...
    > 
    > Yes, that requires a system "Reboot" as they are configured on network startup.
    > 
    > But, if the changes are only to the "WAN Failover:" section, a "Restart Failover" is all that is needed.
    > 
    > Lonnie
    > 
    >> On Jul 13, 2019, at 2:43 AM, Michael Knill <mic...@ip...> wrote:
    >> 
    >> Hi Devs
    >> 
    >> I noticed that when I add or remove an External Failover Destination Route and restart Failover, the routing table does not seem to be updated?
    >> Does it require more than a failover restart?
    >> 
    >> Regards
    >> Michael Knill
    
    It would be nice if the "WAN Failover" stuff could be decoupled from the standard network startup (if possible).
    
    Michael
    
    http://www.mksolutions.info
    
    
    
    
    
    _______________________________________________
    Astlinux-devel mailing list
    Ast...@li...
    https://lists.sourceforge.net/lists/listinfo/astlinux-devel