Re: [Astlinux-devel] Traffic Shaping on backup connection

[David K. <da...@ke...>]

I created some custom firewall scripts to handle this.  Specifically I
wanted to block or severely rate limit certain devices when going over the
cellular connection.  Devices are identified by their MAC address.  If this
is what you are trying to do then let me know and I will share with you the
scripts.

David


On Wed, Feb 20, 2019 at 4:28 PM Lonnie Abelbeck <li...@lo...>
wrote:

> Hi Michael,
>
> Currently only "$EXTIF" (Primary External) is used for traffic shaping via
> the AIF Traffic-Shaper plugin.
>
> You are correct, if shaping was to also apply to the Failover interface
> "$EXT2IF" then a complete different set of shaping parameters would be
> needed.
>
> Lonnie
>
>
>
> > On Feb 20, 2019, at 3:05 PM, Michael Knill <
> mic...@ip...> wrote:
> >
> > Hi Devs
> >
> > I assume that the Astlinux traffic shaping configuration applies to both
> the primary and secondary connections?
> > If so, then is there a way that you can separate them between the two
> connections as you usually don't have them at the same speeds?
> >
> > Thanks
> >
> > Regards
> > Michael Knill
> > _______________________________________________
> > Astlinux-devel mailing list
> > Ast...@li...
> > https://lists.sourceforge.net/lists/listinfo/astlinux-devel
>
>
>
> _______________________________________________
> Astlinux-devel mailing list
> Ast...@li...
> https://lists.sourceforge.net/lists/listinfo/astlinux-devel
>