Calibrate and aligning date error

Stacking program, astrometric (plate) solver, fits file viewer

Brought to you by: han59

Calibrate and aligning date error

Forum: General discussions ASTAP

Creator: Mark Phillips

Created: 2022-12-20

Updated: 2022-12-20

Mark Phillips - 2022-12-20

Hi
I was doing a light curve for a variable star and ran "calibrate and alignment only" on the images before doing photometry. However, all the date-times for each of the aligned images was set to the same one, so there was no time series. This was done by the "calibrate and alignment only" process before the photometry.
Is this correct?
Thanks
Mark

date-after.png

date-before.png

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Mark Phillips - 2022-12-20

And the Results tab after "calibrate and alignment only" shows the Object column as "?" even though it is correct in the FITS header for each file.
Thanks

object-after.png

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

han.k - 2022-12-20

Hello Mark,

The "?" is now corrected in the development version. (Windows only http://www.hnsky.org/astap_setup.exe)

The date error is not correct. I will look into it.

Han

👍
1

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.