Hi, Hugo
If I try to give a dimension to a inclined line software always gives a orthogonal dimensions & not the true inclined length parallel to line.
I didn't noticed this in earlier versions.:-)
Hello Sanjit,
It has always been like this. We only implemented Dimension to be orthogonal ones. I was said that it covered most of the use cases and was much simpler to implement. I've changed this to a feature request but will not focus on it for a while.
Thanks for the report.
Hugo
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello Sanjit,
It has always been like this. We only implemented Dimension to be orthogonal ones. I was said that it covered most of the use cases and was much simpler to implement. I've changed this to a feature request but will not focus on it for a while.
Thanks for the report.
Hugo