Hello,
I have card reader from sattelite receiver with TDA 8204T on board. It has 8pins connector. I didnt find any info how to connect this one to Arduino Uno. I just see pictures about direct connect to smart card.
Thanks before.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
did you check the Wiki (near to the end) there is a description how to connect a TDA 8204T to an Arduino. As there are a lot of different types of SmartCard Readers based on the TDA 8204T out there, there is no "generic" way of connecting to it ... The easiest way is to use the data sheet of the TDA 8204T and try to map the PIN's of the TDA 8204T to the Pins of your "Reader" and then use the description found in the Wiki as a starting point.
Hope this helps
With kind regards
Angus71
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I have card reader from sattelite receiver with TDA 8204T on board. It has 8pins connector. I didnt find any info how to connect this one to Arduino Uno. I just see pictures about direct connect to smart card.
Thanks before.
Hi Vitaliy,
did you check the Wiki (near to the end) there is a description how to connect a TDA 8204T to an Arduino. As there are a lot of different types of SmartCard Readers based on the TDA 8204T out there, there is no "generic" way of connecting to it ... The easiest way is to use the data sheet of the TDA 8204T and try to map the PIN's of the TDA 8204T to the Pins of your "Reader" and then use the description found in the Wiki as a starting point.
Hope this helps
With kind regards
Angus71