Hello Robert, I hope all's well with you.
I had asked about connecting temp sensors in parasite mode on dew controller v309 mosfet and you said yes it could be done by adding a 4.7K resistor between vcc and sig and following the attached image you sent.
I see there is already a 4.7K resistor between them, just a little further upstream in the schematic. Are you saying to add another 4.7K resistor, or will the one that's already there suffice?
You can ignore ignore the left side - its the same, BUT, you just wire up the probe connector differetly - remember to keep the length of the probe lead shorter
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello Robert, I hope all's well with you.
I had asked about connecting temp sensors in parasite mode on dew controller v309 mosfet and you said yes it could be done by adding a 4.7K resistor between vcc and sig and following the attached image you sent.
I see there is already a 4.7K resistor between them, just a little further upstream in the schematic. Are you saying to add another 4.7K resistor, or will the one that's already there suffice?
You can ignore ignore the left side - its the same, BUT, you just wire up the probe connector differetly - remember to keep the length of the probe lead shorter