I wish to add the circuit board temp sensor to the MOSFET V3 stripboard version of MyDew Controller. Could you confirm that the illustrated stripboard connection for VCC of this sensor to D11 is in error and the flying lead should go to the 5V rail at the top of the stripboard? It just seems in variance to the schematic above the stripboard.
Best regards,
Mike
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Robert,
I wish to add the circuit board temp sensor to the MOSFET V3 stripboard version of MyDew Controller. Could you confirm that the illustrated stripboard connection for VCC of this sensor to D11 is in error and the flying lead should go to the 5V rail at the top of the stripboard? It just seems in variance to the schematic above the stripboard.
Best regards,
Mike
yes