First off, thanks a million for your excellent and generous contributions on these pages, very much appreciated.
I have a quick question for you, I got a proper PCB for your mFP2 (DRV8825-HW203) a couple of weeks ago but I now realise that I need to use v1 as I'm using Indi/Ekos; can I continue soldering up the board with everything except the stuff unsupported in v1 or should I go straight to a new bit of perf board?
Thanks!
Ralph
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Yes, just push buttons if you want, display if you want, and temp probe if you want, leave off rest
Remember to use firmware starting with 1xx and apps starting with 1xx (2xx is for version2 and not compatible). Same hardware is used for v1 and v2.
Under Indo etc just use the inbuilt moonlite driver.
Cheers
Robert
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello Mr Brown,
First off, thanks a million for your excellent and generous contributions on these pages, very much appreciated.
I have a quick question for you, I got a proper PCB for your mFP2 (DRV8825-HW203) a couple of weeks ago but I now realise that I need to use v1 as I'm using Indi/Ekos; can I continue soldering up the board with everything except the stuff unsupported in v1 or should I go straight to a new bit of perf board?
Thanks!
Ralph
Yes, just push buttons if you want, display if you want, and temp probe if you want, leave off rest
Remember to use firmware starting with 1xx and apps starting with 1xx (2xx is for version2 and not compatible). Same hardware is used for v1 and v2.
Under Indo etc just use the inbuilt moonlite driver.
Cheers
Robert
Thanks again,
Ralph