Might sound a bit self centred but is this still an on going project. I
am very new to this so do not want to go down a rabbit hole that is a
dead end!
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Yes, if someone finds an issue they can email me and I will put out a fix.
Just to be clear, the project is pretty much done and I am not aware of any issues. I do know that there are other commercial focusers based on this firmware, so its rock solid. It works with ASCOM and INDI.
But I would advise you to look at the myFP2 rather than this one. They both have apprx the same level of knowledge/skills. But myFP2 is much much better and pretty much stable (no outstanding fixes required),
Thanks for the response. Please understand it was written when I was very new to the Arduino concept. Penned by me when I was "ignorant", hopefully not rude!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Might sound a bit self centred but is this still an on going project. I
am very new to this so do not want to go down a rabbit hole that is a
dead end!
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com
Yes, if someone finds an issue they can email me and I will put out a fix.
Just to be clear, the project is pretty much done and I am not aware of any issues. I do know that there are other commercial focusers based on this firmware, so its rock solid. It works with ASCOM and INDI.
But I would advise you to look at the myFP2 rather than this one. They both have apprx the same level of knowledge/skills. But myFP2 is much much better and pretty much stable (no outstanding fixes required),
https://sourceforge.net/projects/arduinoascomfocuserpro2diy/
Regards
Robert
There are other focuser projects still being actively supported, such as myFP2ESP32 and myFP2ESP8266.
Last edit: brownrb 2025-09-01
Thanks for the response. Please understand it was written when I was very new to the Arduino concept. Penned by me when I was "ignorant", hopefully not rude!