just a quick update: (i had most recent driver 290 and firmware325 installed) still unable to connect. several uninstalls and reinstalls, of drivers and firmware, later I lost my cool and asked Device Manager to roll back the drivers for the com port (CH340)...
Bingo! connected without any issues at all.
Hobby for Masochists, but we knew this anyways
Thanks Dr. Robert, Professor of Autofocus!
Michael
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I already have 2 myFPro2 running, one of them is acting as field rotator btw. sweet...
Thanks Dr. Brown!
but due to a moment of idiocy I burnt one of them down by disconnecting the stepper while under power...
had them reprint 5PCBs, built and installed firmware as i did (2?) years ago on 3 of them, but cant get NINA to recognize the newer versions...
Error Message: Reason: Controller is not MyFP2
any suggestions? tahnks a lot!
Hi
It would seem to me that you might be using the wrong firmware with the wrong software.
Is it possible that you loaded the v1 firmware and then tried to use that with myfp2 ascomdriver?
The firmware is v325
https://sourceforge.net/projects/arduinoascomfocuserpro2diy/files/ARDUINO%20FIRMWARE/myFP2_Firmware_325-3.zip/download
The ascom driver is v290
https://sourceforge.net/projects/arduinoascomfocuserpro2diy/files/ASCOM%20DRIVERS/myFP2ASCOMSetup290.exe/download
Regards
Robert
just a quick update: (i had most recent driver 290 and firmware325 installed) still unable to connect. several uninstalls and reinstalls, of drivers and firmware, later I lost my cool and asked Device Manager to roll back the drivers for the com port (CH340)...
Bingo! connected without any issues at all.
Hobby for Masochists, but we knew this anyways
Thanks Dr. Robert, Professor of Autofocus!
Michael