I have found that when using Sharpcap and select the focus assistant it starts ok then will stop moving the focuser. when I investigate it appears that the max steps has changed to the same as the position so it has no where to go!
using version 334 ULN2003_M_ML_F_BT
latest sharpcap version 4.1.11821
Ascom driver version 301
Many thanks
Dave W
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Dave
I am not someone who uses Sharpcap, and its been many years since I did have a look at it, so just letting you know there are many things I do not know.
I would need the log files from myFP2 ASCOM Driver and Sharpcap to make any sensor of what is going on. Without the logs I couldnt know where to look.
BTW, is this just happened because of the 334 update, or it happened before, or did you just update sharpcap recently, or you just tried that for the first time. I guess what I am saying is that if is just happening now, but was okay before, it would point to something that has changed that caused it to break?
The note about maxstep and position is good find, that would help me to parse the logfiles.
regards
Robert
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have found that when using Sharpcap and select the focus assistant it starts ok then will stop moving the focuser. when I investigate it appears that the max steps has changed to the same as the position so it has no where to go!
using version 334 ULN2003_M_ML_F_BT
latest sharpcap version 4.1.11821
Ascom driver version 301
Many thanks
Dave W
Hi Dave
I am not someone who uses Sharpcap, and its been many years since I did have a look at it, so just letting you know there are many things I do not know.
I would need the log files from myFP2 ASCOM Driver and Sharpcap to make any sensor of what is going on. Without the logs I couldnt know where to look.
BTW, is this just happened because of the 334 update, or it happened before, or did you just update sharpcap recently, or you just tried that for the first time. I guess what I am saying is that if is just happening now, but was okay before, it would point to something that has changed that caused it to break?
The note about maxstep and position is good find, that would help me to parse the logfiles.
regards
Robert