Compile problem

Version 2 of the myFocuser Project

Brought to you by: brownrb

Compile problem

Forum: General Discussion

Creator: Domenico Massari

Created: 2019-02-28

Updated: 2019-03-01

Domenico Massari - 2019-02-28

Hi, I have a problem when I compile the sketc 279. I want to enable the infrared control but I get this error

Focuserv279_DRV8825_HW203: 1947: 13: error: 'motorSpeed' was not declared in this scope

motorSpeed = SLOW; ^

exit status 1
'motorSpeed' was not declared in this scope.

I do not have problems compiling the 277 sketc with infrared control.
Thanks for an answer.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

brownrb - 2019-03-01

Hi Domenico
I am only guessing at what your comilation directives are - you did not mention what is enabled and what is commented out

v279 is not supported.

Please try v280

regards
Robert

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.