Dear all,
I'm trying to use this beautiful project but I would like to use my board that is a GT2560 Rev A+ taken from a 3D printer geeetech. I need to use it because it has embedded 5 controller for NEMA17 motors with the drivers A4988 that I will use for other stuff...
I uploaded the firmware without issue but I'm not able to configure the sketch for using my motors... somebody or Robert Brown can help me please?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I cant give any help on the use of GT2560. Also, a 3D printer motor is unlikely to be suitable for use in this project. 3D print motors tend to draw much higher current loads that the recommended steppers.
regards
Robert
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Dear all,
I'm trying to use this beautiful project but I would like to use my board that is a GT2560 Rev A+ taken from a 3D printer geeetech. I need to use it because it has embedded 5 controller for NEMA17 motors with the drivers A4988 that I will use for other stuff...
I uploaded the firmware without issue but I'm not able to configure the sketch for using my motors... somebody or Robert Brown can help me please?
Hi Luca
I cant give any help on the use of GT2560. Also, a 3D printer motor is unlikely to be suitable for use in this project. 3D print motors tend to draw much higher current loads that the recommended steppers.
regards
Robert