Automatically haltes after a few commands

Version 2 of the myFocuser Project

Brought to you by: brownrb

Automatically haltes after a few commands

Forum: General Discussion

Creator: Fishie Chung

Created: 2022-09-29

Updated: 2022-10-01

Fishie Chung - 2022-09-29

Hi, I am new to Myfocuserpro2.

I am currently using a Nema17 stepping motor with a DRV8825. I finished everything, but the program automatically disconnects after a few turns.

Is this a known problem and are there any solution to this?

Many thanks!

Fishie

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Fishie Chung - 2022-09-30

I seemed to have solved the problem from updating the firmware from 315 to 317. Many thanks!

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Patrick PASC - 2022-10-01

Hello Fishie Chung.
Yes, Firmware V317 is not stabilized yet. Robert has found the anomaly and a new Firmware V318 will soon be available. I tested it and it works very well. Still a little patience.
Cordially,
Patrick

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.