I have PCB boards on order from the file DRV8825_M-MT-F-BT-12-gerbers.zip and have a nano board and Stepstick A4988 (DRV8825 board). The question is the correct firmware to use with this. There will be no display or pushbuttons. The intent is to strictly control it from a PC using ASCOM drivers. With all the layers involved, getting the right combination of firmware files is important.
It would appear that either myFP2_DRV8825_312-1 or myFP2_DRV8825HW203_312-1 is correct but the labels are not clear. Additionally, can I assume that the correct set of libraries is myFocuserPro2libraries.
I thank the group in advance for any help.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
DRV8825_M-MT-F-BT-12-gerbers.zip
firmware is
myFP2_DRV8825_312-1
attached is firmware configured with nodisplay, no pushbuttons, no temperature probe, no nothing
attached is required libraries
I have PCB boards on order from the file DRV8825_M-MT-F-BT-12-gerbers.zip and have a nano board and Stepstick A4988 (DRV8825 board). The question is the correct firmware to use with this. There will be no display or pushbuttons. The intent is to strictly control it from a PC using ASCOM drivers. With all the layers involved, getting the right combination of firmware files is important.
It would appear that either myFP2_DRV8825_312-1 or myFP2_DRV8825HW203_312-1 is correct but the labels are not clear. Additionally, can I assume that the correct set of libraries is myFocuserPro2libraries.
I thank the group in advance for any help.
DRV8825_M-MT-F-BT-12-gerbers.zip
firmware is
myFP2_DRV8825_312-1
attached is firmware configured with nodisplay, no pushbuttons, no temperature probe, no nothing
attached is required libraries
Last edit: brownrb 2022-05-11
Thank you. It is not very clear how the file naming works and the trial and error method can get tedious when you don't have a known good combination.