Do you have any idea when you'll incorporate TempComp and TempCompAvailable properties? The one thing missing in my focuser is to have internal temperature compensation running while under the control of SGP which uses autofocus. Before running autofocus, SGP will set TempComp to false, run the AF routine and then set TempComp back to true again. This would be immensely helpful for long exposures when temps are changing rapidly.
Thanks for this great project.
Tim
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Tim
:-)
Its been there for quite a while now, in firmware. the PDF has a whole chapter on it with examples, and it is in both Windows App as well as ASCOM driver. If its not in the version you have please update.
Regards
Robert
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Outstanding! I am curently using an older version of Pro and have been wanting to build a Pro2 version. I was going by Appendix A of the manual where it states that the TempComp and TempCompAvailable properties are not yet implemented. I did read the chapter on temperature compensation but it was not clear that it could be enabled and disabled via ASCOM.
Thanks again.
Tim
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Robert:
Do you have any idea when you'll incorporate TempComp and TempCompAvailable properties? The one thing missing in my focuser is to have internal temperature compensation running while under the control of SGP which uses autofocus. Before running autofocus, SGP will set TempComp to false, run the AF routine and then set TempComp back to true again. This would be immensely helpful for long exposures when temps are changing rapidly.
Thanks for this great project.
Tim
Hi Tim
:-)
Its been there for quite a while now, in firmware. the PDF has a whole chapter on it with examples, and it is in both Windows App as well as ASCOM driver. If its not in the version you have please update.
Regards
Robert
Outstanding! I am curently using an older version of Pro and have been wanting to build a Pro2 version. I was going by Appendix A of the manual where it states that the TempComp and TempCompAvailable properties are not yet implemented. I did read the chapter on temperature compensation but it was not clear that it could be enabled and disabled via ASCOM.
Thanks again.
Tim
I will have to update the Appendix A... in the main pdf