Hello. I have built the FIRBT pcb with a DRV8825 controller. Looking at the schematics I see that these 3 ways of moving the focuser don't share any pins... IR uses D9, BT uses D10 and D11, and Push buttons A0.
What is the problem then to enable them at the same time? The arduino code allows BT and PB together, but IR is not allowed to coexist with BT or PB...
I would be great to have all options open with the same code.
Cheers
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
No can do. It is not about pins - it is about use of the hardware timer within the arduino. We rely on libraries written by other people - and what they chose to use - outside our control
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello. I have built the FIRBT pcb with a DRV8825 controller. Looking at the schematics I see that these 3 ways of moving the focuser don't share any pins... IR uses D9, BT uses D10 and D11, and Push buttons A0.
What is the problem then to enable them at the same time? The arduino code allows BT and PB together, but IR is not allowed to coexist with BT or PB...
I would be great to have all options open with the same code.
Cheers
No can do. It is not about pins - it is about use of the hardware timer within the arduino. We rely on libraries written by other people - and what they chose to use - outside our control