controller not working after firmware update

[Robert Calise]

Hello
i am just recovering from a hard drive failure
loaded the the current windows app2.4.3 and connected to the controller eveything looked and ran fine then i noticed a firmware update 280 so i loaded that now the motor wont turn i can hear it wine but no movment i tried diff speed settings the pitch of the wine changed but no movment
my controller is an minimal l293d shield connected to a uno with a nema 17 pg 27 stepper with temp i loaded the l293d firmware I set the steps to 5370 steps to motor port 2 am i missing somthing in the firware it all worked before the firmware update i at a lost to what is wrong

[brownrb]

Hi Robert
Apologies but I only just discovered your post. Did you manage to resolve your issues?
You should be using Focuserv281_L293D.ino
#define STEPSPERREVOLUTION = 5370; // NEMA17-PG27 motor
// #define STEPSPERREVOLUTION 200 // NEMA17 motor Full steps

Regards
Robert