yesterday i got my MYFP2M PCB, Arduino and DRV 8825. Just want to use temp Probe, leds, and the the programm switch, no Buzzer, Wifi etc.
But iam a bit confused about the parts i need because the naming in list rev 12 is different to pcb rev13 i think. And i found just the rev12 listing.
I have already soldered:LM7808, PTC Fuse,100/0,33/0,1uF. D2 Diode,D1 Diode.
But wich resistors are also needed?
rev12 listing says R3 for probe but on the pcb it makes no sense to me, its conected to the oled header and Arduino?
Sebastian
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Sebastian
My apologies, I had a closer look tonight and I agree that the parts list does not match the PCB release.
I attach an updated parts list for the myFP2M DRV8825 PCB,
I color coded the options like OLED, Temperature Probe etc
If you decide to not use an OLED display, you can now quickly identify the parts you can leave out, they do not need to be purchased or installed on the board.
I did not check the other PCB options, only the DRV8825 worksheet against rev13 of the board.
I hope that this help you, and plase, dont hesitate to contact me or write a post that I cam put things right and assist you in this project
Hi,
yesterday i got my MYFP2M PCB, Arduino and DRV 8825. Just want to use temp Probe, leds, and the the programm switch, no Buzzer, Wifi etc.
But iam a bit confused about the parts i need because the naming in list rev 12 is different to pcb rev13 i think. And i found just the rev12 listing.
I have already soldered:LM7808, PTC Fuse,100/0,33/0,1uF. D2 Diode,D1 Diode.
But wich resistors are also needed?
rev12 listing says R3 for probe but on the pcb it makes no sense to me, its conected to the oled header and Arduino?
Sebastian
Hi Sebastian
My apologies, I had a closer look tonight and I agree that the parts list does not match the PCB release.
I attach an updated parts list for the myFP2M DRV8825 PCB,
I color coded the options like OLED, Temperature Probe etc
If you decide to not use an OLED display, you can now quickly identify the parts you can leave out, they do not need to be purchased or installed on the board.
I did not check the other PCB options, only the DRV8825 worksheet against rev13 of the board.
I hope that this help you, and plase, dont hesitate to contact me or write a post that I cam put things right and assist you in this project
regards
Robert
Hi Robert,
thank you, that will help me.
Sebastian