Hi there,
I recreated the focuser. I used a DS18B20 with a 10 cm lead. I used a 4.7 kOhm resistor as a pull-up.
My problem is that the displayed temperature is about 7 degrees Celsius higher than in real life. When entering the offset of -7 degrees in the Ascom driver, the temperature is initially displayed normally and always changes to the one without offset. After about 4 seconds it goes back to the one with offset. And always alternately.
Please can you help me?
Greeting and great job from you.
Micha
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi there,
I recreated the focuser. I used a DS18B20 with a 10 cm lead. I used a 4.7 kOhm resistor as a pull-up.
My problem is that the displayed temperature is about 7 degrees Celsius higher than in real life. When entering the offset of -7 degrees in the Ascom driver, the temperature is initially displayed normally and always changes to the one without offset. After about 4 seconds it goes back to the one with offset. And always alternately.
Please can you help me?
Greeting and great job from you.
Micha