Sorry, no it does not. The choices are listed in the PDF.
But having said that the DRV code will work with the A4998 stepper - the only thing though is that microstepping is handled differently, so if you were using full stepping then you can use the drv code immediately with the a4998
Cheers
Robert
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello that means if I take full stepping I can use the Nexion display is that correct?
Are there any other advantages or disadvantages regarding the PCB for 4988 or 8825.
PS. can it be that you have a typo in the Gerber file on the circuit board I think it says IC2 4988 instead of IC2 4998?
Thanks greetings Jan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello that means if I take full stepping I can use the Nexion display is that correct?
Are there any other advantages or disadvantages regarding the PCB for 4988 or 8825.
PS. can it be that you have a typo in the Gerber file on the circuit board I think it says IC2 4988 instead of IC2 4998?
Thanks greetings Jan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
Does the PCB with Stepper Driver 4988 Support the Nextion 3.5" Enhanced Touch Display?
best regards Jan
Sorry, no it does not. The choices are listed in the PDF.
But having said that the DRV code will work with the A4998 stepper - the only thing though is that microstepping is handled differently, so if you were using full stepping then you can use the drv code immediately with the a4998
Cheers
Robert
Hello that means if I take full stepping I can use the Nexion display is that correct?
Are there any other advantages or disadvantages regarding the PCB for 4988 or 8825.
PS. can it be that you have a typo in the Gerber file on the circuit board I think it says IC2 4988 instead of IC2 4998?
Thanks greetings Jan
Hello that means if I take full stepping I can use the Nexion display is that correct?
Are there any other advantages or disadvantages regarding the PCB for 4988 or 8825.
PS. can it be that you have a typo in the Gerber file on the circuit board I think it says IC2 4988 instead of IC2 4998?
Thanks greetings Jan
The writing is pretty small but I am sure it says A4998
Using a drv8825 then of course with the correct CB and wiring, the micro-stepping works and is supported by the Nextion display.
Nexion Display was connected thru the Bluetooth Modul Pins right? so i cant use Bluetooth and Nexion?
best regards Jan
Nope, the bluetooth interface is used to communicate with the Nextion display, so if using Nextion then bluetooth is not available.