Hi Robert
I made the last update and I have a problem with the ascom v109 driver under NINA 'unable to connect com port is not defined' back to v108 and everything works What do you think ?
Best regards
Philippe
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I posted this in Updates discussion yesterday
25-Oct-2023
Advice Notice: ASCOM Driver issues
I am working through a number of issues which are caused by both the firmware and ascom driver.
At times, during initial operations, incorrect settings (angle) may occur, however this seems to settle down after a few moves. I believe this issue dates back to firmware v125-00
I do not have a time frame on when this will be fixed.
Regards
Robert
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
As mentioned, there is an issue and I will work on it.
Having just come home from Hospital today due to coronary attack, please be a little patient.
Advice Notice: ASCOM Driver issues
I am working through a number of issues which are caused by both the firmware and ascom driver.
At times, during initial operations, incorrect settings (angle) may occur, however this seems to settle down after a few moves. I believe this issue dates back to firmware v125-00
I do not have a time frame on when this will be fixed.
Regards
Robert
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi.
Does anyone know where to download Ascom Driver version 1.08? I would like to run the rotator but unfortunately driver 1.09 does not work yet. Thank you in advance.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Robert
I made the last update and I have a problem with the ascom v109 driver under NINA 'unable to connect com port is not defined' back to v108 and everything works What do you think ?
Best regards
Philippe
I posted this in Updates discussion yesterday
25-Oct-2023
Advice Notice: ASCOM Driver issues
I am working through a number of issues which are caused by both the firmware and ascom driver.
At times, during initial operations, incorrect settings (angle) may occur, however this seems to settle down after a few moves. I believe this issue dates back to firmware v125-00
I do not have a time frame on when this will be fixed.
Regards
Robert
Hello Robert.
I have exactly the same problem as Philippe.
Back to version 108 for now.
Sincerely
Patrick
Note that I also have the same problem with APT.
It seems that the driver does not remember the selected COM port.
As mentioned, there is an issue and I will work on it.
Having just come home from Hospital today due to coronary attack, please be a little patient.
Advice Notice: ASCOM Driver issues
I am working through a number of issues which are caused by both the firmware and ascom driver.
At times, during initial operations, incorrect settings (angle) may occur, however this seems to settle down after a few moves. I believe this issue dates back to firmware v125-00
I do not have a time frame on when this will be fixed.
Regards
Robert
No problem Robert.
Rest well, health is important.
Get well soon.
Hi.
Does anyone know where to download Ascom Driver version 1.08? I would like to run the rotator but unfortunately driver 1.09 does not work yet. Thank you in advance.
hi attached V 108 from the ascom driver
regards
Thank you very much, it works.