Hi everyone!
Does anyone eperiences temperature issues with the stepper motor?
I run the hardware with the ULN2003 driver board and the 28BYJ-48 stepper motor.
Setting "coil power" on or off does not make a difference.
The moter still gets very hot!
Help/recommendations are very much appreciated :-)
best
Klaus-P.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi everyone!
Does anyone eperiences temperature issues with the stepper motor?
I run the hardware with the ULN2003 driver board and the 28BYJ-48 stepper motor.
Setting "coil power" on or off does not make a difference.
The moter still gets very hot!
Help/recommendations are very much appreciated :-)
best
Klaus-P.
Try running the controller with 9V instead of 12V?
Check proper wiring connection, I had this issue with a Nema 14 steper motor and it was caused by a wrong wiring connection.