When I drag & drop my files into apng assembler, they do not retain their original file names past frame 4, and when I output the file the animation's frames are completely out of order (causing the animation to spasm wildy). The source files are all sequentially numbered; is there any way to get them in their correct order without having to place them in the program one at a time? (there are over 250 frames)
I tried to replicate the situation, but it's working fine here.
Not sure why you're getting short file names on your system...
File names should look the same in the file system and in the program window.
I actually figured out what the issue was on this one. The file path was too long. The images I added were located too many subfolders down from the program location. Once I moved them up a couple tiers to a new folder, then it was able to pull them in the proper order.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
When I drag & drop my files into apng assembler, they do not retain their original file names past frame 4, and when I output the file the animation's frames are completely out of order (causing the animation to spasm wildy). The source files are all sequentially numbered; is there any way to get them in their correct order without having to place them in the program one at a time? (there are over 250 frames)
I tried to replicate the situation, but it's working fine here.
Not sure why you're getting short file names on your system...
File names should look the same in the file system and in the program window.
I actually figured out what the issue was on this one. The file path was too long. The images I added were located too many subfolders down from the program location. Once I moved them up a couple tiers to a new folder, then it was able to pull them in the proper order.
Ah, good to know!