[Amforth] Atmega328p

[Mark M. <m.m...@gm...>]

What am I missing?

I am attempting to put amforth on a Atmega328p following more or less the
Amforth Users Guide (which was written for Amforth 4.2).  I am working from
Linux.

Using the example template.asm with the dict_appl.inc and dict_appl_core.inc
and the applturnkey.asm in ver 4.5 - it assembles without errors under
Studio 4 (4.18) running under wine.  Using avrdude 5.1 and either a
Avrispmkii or avr-pg2, I load the flash and the eeprom with their respective
hex files assembled under Studio 4.  Using the factory default settings OR
changing the fuse bytes, I am unable to pull up a forth prompt on the serial
port (9600 8n1).  The 328p is wired only to either a 10 or 6 pin ISP header
(depending on which programmer - both seem to work fine), a 16 mhz crystal
with 22pf caps (the only change in the template.asm file), and a max 232 for
the serial port.  This "simple wiring" has been triple checked.  The default
fuses (as found on a new chip) are high fuse: 0xD9 which I have set to
either 0xD1 or 0xD0 (BOOTRST ?) and low fuse default 0x62 which I reset to
0x67.  Guidance on the proper fuse settings is conFUSing.

What am I missing?