first of all - APM is such a great tool - thx so much for it!
I had an issue upgrading to the newest version 4.3 on my DS918+ with DSM 7.2.2 Update 3. The install wizard suggests to deselect 'Run after installation' on the next wizard page () - however, there was no such checkbox on that page () and therefore the automatic run after installation failed () leaving the package in a "damaged" state (). The "Repair" option just downloaded the package again and started the installation from scratch.
I was able to fix it for me with these steps:
* Backed up my configuration found in /volume1/@appstore/AdvancedPowerManagerDSM7/store/config/default
* Uninstalled APM
* Installed APM - this time the checkbox "Run after installation" became visible!
* Copied the privilege as instructed
* Restored my previously backed up configuration
Hi
first of all - APM is such a great tool - thx so much for it!
I had an issue upgrading to the newest version 4.3 on my DS918+ with DSM 7.2.2 Update 3. The install wizard suggests to deselect 'Run after installation' on the next wizard page (
) - however, there was no such checkbox on that page (
) and therefore the automatic run after installation failed (
) leaving the package in a "damaged" state (
). The "Repair" option just downloaded the package again and started the installation from scratch.
I was able to fix it for me with these steps:
* Backed up my configuration found in
/volume1/@appstore/AdvancedPowerManagerDSM7/store/config/default* Uninstalled APM
* Installed APM - this time the checkbox "Run after installation" became visible!
* Copied the privilege as instructed
* Restored my previously backed up configuration
Hth
Last edit: Daniel 2025-04-18