Re: [Emc-developers] RTAI 5.3.3 Beta release for LinuxCNC (Needs testing, esp on Intel)

Hi Alec,
first thank you for your time and effort.
really appreciate it.

I tested with 6 Intel (3x I5 & 3x Atoms)  and 1 AMD CPU on motherboards 
from different vendors.
(I've one further Fujitsu Industrial ITX board with a Pentium J5005 
here, but this insists of booting with UEFI.)
Attached the histogram screenshots.

I started linuxcnc RIP and picked latency histogram from the menu.

Works fine so far, but in rare cases elapsed time counter stopped 
increasing, while the other program functions still work.
So i was able to exit and restart.

Whats very nice, that on all machines starting, stopping and restating 
programs that use RTAI is no problem anymore.
That wasn't the case in the past.
Back then in most cases the machine freezes and had to be rebooted.
annoying when doing RTAI depending development.

My own RIP Source didn't compile against the new kernel, but it has not 
been synced to the master for roughly one year.
Fixing this will be may next task and then I'll switch to the new kernel.

Thanks again.

Rainer

Motherboard: Intel DN2800MT

Motherboard: ASUS Prime A320M

Motherboard: ASUS PBZ77

Motherboard: ASUS H81+

Motherboard: ASROCK AD2550

Motherboard: Fujitsu W3353 (label on the mainboard, the name is D3something)

IEI DRPC100