When I create new file, paste to it source of any web page, save as *.html or *.php it recognize the language and change to html or php but doesn't highlight code. I have to change language to any other and again to html or php, or close file and open it again to have my code highlighted.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
>> "
When I save a new (normal text) file with an extension for another language, the language will be selected. However, the syntax highlighting won't be updated. Switching doesn't help. Only after I pressed enter at the top of the document, did I recognize what I wrote because of the highlighting finally having been applied.
" <<
I haven't noticed this in any version prior to the V5.0 Official Release.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
When I create new file, paste to it source of any web page, save as *.html or *.php it recognize the language and change to html or php but doesn't highlight code. I have to change language to any other and again to html or php, or close file and open it again to have my code highlighted.
Reported also in the message
"File saved: syntax highlighting not updated"
By: Nobody/Anonymous (nobody) - 2008-07-11 13:14
http://sourceforge.net/forum/message.php?msg_id=5089150
in the Notepad V5.0 Official Release thread
"Notepad++ v5 Official Release is available" (Open Discussion forum)
http://sourceforge.net/forum/forum.php?thread_id=2107810&forum_id=331753
Message contents:
>> "
When I save a new (normal text) file with an extension for another language, the language will be selected. However, the syntax highlighting won't be updated. Switching doesn't help. Only after I pressed enter at the top of the document, did I recognize what I wrote because of the highlighting finally having been applied.
" <<
I haven't noticed this in any version prior to the V5.0 Official Release.
Will be fixed in v5.0.1
Don