Hello,
I use ISE with notepad++. With the following commande line, I open a file an I reach a line.
"C:\\Program Files\\Notepad++\\notepad++.exe" -n$2 $1
But when the fill is open, the cursor don't go on the specified line.
Is somebody could help me?
Thank you
Arnaud
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
It is a known bug and will be fixed in the next release.
If you rely heavily on it, I suggest you revert to a prior release like 4.9.1 or 4.9, I believe I introduced the bug in 4.9.2 (accidental of course ;))
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I use ISE with notepad++. With the following commande line, I open a file an I reach a line.
"C:\\Program Files\\Notepad++\\notepad++.exe" -n$2 $1
But when the fill is open, the cursor don't go on the specified line.
Is somebody could help me?
Thank you
Arnaud
It is a known bug and will be fixed in the next release.
If you rely heavily on it, I suggest you revert to a prior release like 4.9.1 or 4.9, I believe I introduced the bug in 4.9.2 (accidental of course ;))
"[bug] "go to line number" in command-line" (Open Discussion forum)
http://sourceforge.net/forum/forum.php?thread_id=2044761&forum_id=331753
"command line -nxx('go to line) not working(?)" (Help forum)
http://sourceforge.net/forum/forum.php?thread_id=2043556&forum_id=331754