Search Results for "voltage"

...With the Betaflight OSD you can get all relevant flight metrics directly into your FPV video feed. An easy-to-use drag-and-drop configuration allows the placement of values like used mAh and LiPo Voltage readings. Additionally, you can change most firmware settings using stick commands without even removing your goggles.

Cpuspeedy is simple and easy to use program which allows you to change the clock speed and voltage of the CPUs on the fly, using the Linux's CPUFreq driver. Use it and you should save battery consumption and reduce the temperature of your laptop.

...The interface is very flexible -- everything from a web browser, to read and writing directly to the chip's "file" to integrating with your programs -- even over the internet. There is a growing number of 1-wire sensors: temperature, voltage, humidity, light, ultraviolet, pressure, thermisters, thermocouples, programmable microcontrollers, relays, lights, LCD panels, etc

iWattnick aims to be a top-class computer for e-bikes, e-scooters, e-motorcycles. It is equipped with a large B/W screen, two buttons, accelerometer, magnitometer, current and voltage sensors, light sensor, internal temperature sensor, battery-backed real-time clock, a buzzer and has connection ports for external speed sensor (motor Hall, phase or reed switch), a Bluetooth SPP dongle, up to three temperature sensors (TMP36, LM35, KTY83 etc), cadence sensor, throttle handle, output to controller throttle input. ...

The project contains the following modules: * Main Controller Module which is responsible for scheduling and switching the water pumps, monitoring the water level and temperature, and reading the Soil Moisture Sensors. The module has a 4 line alphanumeric LCD that makes the system easy to use. * Sensor Controller Module is attached to the Main Controller Module via RS232 interface. This module is the master controller for the Soil Moisture Sensors and also contains a Dallas 1-Wire...

An applet for the GNOME panel to monitor hardware sensor readings (temperature, voltage and fan) under Linux.

AVR-HV is high voltage parallel programmer for Atmel AVR series microcontrollers. AVR-HV allows programming, reading, verifying and configuring AVR microcontrollers with its high voltage programming interface and it connected with PC using USB interface.

A small daemon to adjust cpu speed and voltage (and not only) for kernels using any of the cpufreq drivers available. The CpuFreq Linux kernel capability is available in all recent kernels.

Processor Hardware Control is a patch for the Linux Kernel which provides a kernel interface for changing the voltage/frequency pairs of processors from userspace.

AX10412 Voltage Measurement Module Linux device driver.