Search Results for "oscillator"

Iperf here is a means of measuring networks - capacity & latency (including ECN) over sockets both TCP and UDP. The goals include maintaining an active iperf code base across a broad set of platforms and operating systems. This is a multi-threaded design that scales with the number of CPUs or cores within a system. It supports both high impact and low impact techniques to obtain and report network performance. Current release: 2.2.1, Nov 4th, 2024 About iperf 2 and iperf3: Read...

EM-65C02 emulates a Western Design Centre (WDC) 65C02 microprocessor on a Microchip PIC24/33 microcontroller. The code supports varying amounts of RAM and ROM depending on the features of the host device. The emulation speed depends on the device and its oscillator configuration. A PIC24EP running at 70MIPS has emulates a 65C02 running at about 6Mhz. The example code configuration uses a copy of the BBC BASIC ROM image and a simulation of enough of the Acorn MOS to make the BASIC work using a serial UART connection.

serialLCD is Arduino based open-source project. It contains ATmega8 with given firmware file & the arduino library. The ATmega8 can be replaced by ATmega168/328. ATmega8 uses its 8MHz internal oscillator to reduce hardware (atmega8 no-xtal bootloader is used). The arduino library uses SoftwareSerial internally to communicate ATmega8 via digital pin 6 (only for uno/duemilanove or clone with atmega8/168/328, not for mega & due). Only one wire simplex serial communication at baudrate 9600 is required to communicate with serialLCD module. ...