Search Results for "uno"

Small but efficient communication library that allows your sketches the interfacing with Siemens PLC. Works starting from Arduino UNO with the W5100 ethernet shield.

..."Four wire" SPI and 8 bit parallel interfaces are supported. Due to the lack of GPIO pins, the 8-bit parallel interface is NOT supported on the ESP8266. 8 bit parallel interface TFTs (e.g. UNO format mcufriend shields) can use with the STM32 Nucleo 64/144 range or the UNO format ESP32. ILI9341 and ST7796 SPI-based displays are recommended as starting points for experimenting with this library. The library supports some TFT displays designed for the Raspberry Pi (RPi) that are based on a ILI9486 or ST7796 driver chip with a 480 x 320-pixel screen.

This project is a partial overhaul of the Arduino hardware library, i.e. the main source files that make the core library. The intent is to reduce the overhead introduced by the initial library and eliminate the numerous function calls whenever direct register access is possible.

...ATmega8 uses its 8MHz internal oscillator to reduce hardware (atmega8 no-xtal bootloader is used). The arduino library uses SoftwareSerial internally to communicate ATmega8 via digital pin 6 (only for uno/duemilanove or clone with atmega8/168/328, not for mega & due). Only one wire simplex serial communication at baudrate 9600 is required to communicate with serialLCD module. The library & firmware file is released in public domain as open-source project. Feel free to edit/improve/share it. *** Raspberry Pi python library added. ...

...It has the same features as Megasquirt 1 and can be tuned in MegaTunix, MegaTune or TunerStudio as a Megasquirt 1 B&G2.0-3.0. The code is compiled for the ATmega328p so the supported boards should be: - Arduino Uno - Arduino Duemilanove - Arduino Diecimila - Arduino NG - Arduino Extreme v2 - Arduino Extreme Note: only tested on Arduino Duemilanove No schematics are available yet, but please have a look at the MegasquirtAVR schematics. It is meant for the ATmega128 so not pin compatible.