Search Results for "auto"

A modern, stand alone browser-based serial terminal for UART communication with microcontrollers, embedded devices, and IoT hardware. No installation required - just open in your browser and connect to your serial device. Just unpack the zip file into local folder and open index.html in Chrome/Edge/Opera. Works on Windows/Linux/MaOS

Mainly designed for embedded & software engineers, UartVide is a flat-UI and straightforward and lightweight RS232 serial port communication utility that allows you to configure the connection parameters and communicate via the port. UartVide runs on all platforms supported by PySide2 including Windows, Linux. (MyTerm was renamed to UartVide from version 2.4)

smartCOM is a graphical serial device terminal, it's an alternative to minicom. It is aimed mainly at hardware developers who need a gui test tools to talk to their custom hardware. The GUI is written using the wxWidgets library, and using the tinyxml to save or load config. http://gnssinfo.com/2012/11/21/wiki-smartcom/

The RS232 Automatic Sender V1.0.2 sends a preconfigured message on the RS232 serial port. Any char can be sent and delays can be inserted between chars if needed. The program automatically sends the message when started and it will automatically close when done. The program was created to send messages to a Sharp LCD TV that could receive commands over the RS232 port.

A terminal communication program that is able to open multiple terminal windows in a multiple document interface (MDI). Terminal windows include serial ports and ethernet ports (TCP and UDP). Every configuration is stored in a tree view for quick acc

Simple Serial COM read/write program. I needed it for Caller ID read modem driver so it has command auto complete for AT commands. It is a good replacement for HyperTerminal. Made for .NET Framework 2.0