Search Results for "communication program"

This program supports TSNK-lab ICX285AL cameras, QHY5, QHY6, QHY9, QHY8L, QHY10, DSI2PRO, DSLR. It works with Mono images of 8, 12, 16 bits and RGB images of 24, 48 bits. Photo and video modes can be used. Histogram control of preview is available. There are two modes of capture: single frame mode and series.

This tool can improve communication based on communication boards and iconographic symbols. Users with motor and communication disturbs can communicate by selecting characters on a computer screen using expressions like Blink (simultaneous blink left and right eye), individual blink(blink left or right eye), smile, raise eyebrow and some others. In this version, the tool allows users only select character to form phrases and listen letters and/or words (configurable). With some...

TILP (formerly GtkTiLink) can transfer data between Texas Instruments graphing calculators and a computer. It works with all link cables (parallel, serial, Black/Gray/Silver/Direct Link) and it supports the TI-Z80 series (73..86), the TI-eZ80 series (83PCE, 84+CE), the TI-68k series (89, 92, 92+, V200, 89T) and the Nspire series (Nspire Clickpad / Touchpad / CX, both CAS and non-CAS). The project is now managed on Github, https://github.com/debrouxl/tilp_and_gfm . It uses the libti*...

...This applies to the Celestron: NexStar GPS, NexStar GPS-SA, NexStar iSeries, NexStar SE Series, NexStar GT, CPC, SLT, Advanced-VX, Advanced-GT, CGE, CGEM etc. SkyWatcher: EQ5, HEQ5, EQ6 (Pro), AZ-EQ5 GT, AZ-EQ6 GT, EQ8 etc. and the corresponding Orion mounts. Communication to the hand control is 9600 bits/sec, no parity and one stop bit via the RS-232 port on the base of the hand control. For extended example how to use this perl module look in to the distribution folder for nexstarctl.pl. This program is a complete console tool to control NexStar telesctopes based on NexStarCtl module. To control network based telescopes nexbridge must be used on the remote site. ...

This this program transparently proxies the serial commands supported by the Celestron NexStar hand control over the network, so that the telescope can be controlled over the network. It is recommended to be used with libnexstar or NexStarCtl on the remote end. However it proved to be very useful for exporting all kinds of telescope mounts on the network like Sky-Watcher, Meade etc.

This program is a logical signal analyzer tool for Arduino which helps listening TWI communication or UART with low baud rates (19200).

...If you like, hate or simply use this software, if you find any bug or have any request, please do not hesitate to let me know through the services offered by the site that hosts the project or through my Facebook page (http://facebook.com/koalakoker). And (if you think it's the case) do not hesitate to recommend the program to your friends.

...Although written for this specific task it is easy to adopt for any experimental task which changes hardware parameters and waits for a specific condition before proceeding. The graphical interface (QT4) includes plotting (matplotlib), instrument configuration/monitoring and a program step creator. The communication with the hardware is independent of the GUI and any number of devices can be selected. To modify the code for any other task only the hardware interface needs to be redefined.

A particle swarm optimization demo written by students in the digital communication msc program (2010) at uni-kiel.