Search Results for "computer controller"

...will send the corresponding USB keystroke to the host computer. You can program *any* USB Consumer Device control code too...for example, Play, Pause, Mute, Volume up, Volume down, and many others.

...Parrot advertises the toy as an advance in gaming because the control devices will project a virtual reality allowing users to play with their physical drone with an enhanced version on their controller where bullets or hot air balloons must be avoided in the virtual world. KIPR, KISS Institute for Practical Robotics is an organization that facilitates the learning of robotics programming in middle and high school students to peak an interest in computer science. To do this they hold competitions around the world called botball where students program autonomous land robots to perform various sets of tasks. ...

A robotic DIY styrofoam cutter consisting of one rotational and two translational axes. It cuts a variety of shapes out of styrofoam-like materials using a hot wire. This project documents the necessary hardware and software parts. Don't miss the follow-up project at http://raumschaum.org Its goal is to further develop hardware and software into an user friendly application.

A small program for an Arduino compatible micro controller that controls the flight of a model (water-) rocket. It does control the preparation of the recovery system, has automatic launch detection, an apogee detection system, parachute deployment, and safety timers. All this is managed with the most simple one button and one LED user interface.

Spa/Hot Tub controller based on Z-World's Rabbit single board computer, BL2000. The digial outputs control Solid State relays to switch 240VAC power to the heater element and 120VAC power to the water pump.

Software application, firmware and U.I. for 4-motors 3-axis milling machine, open hardware, software and mechanics. See also project in details for schematics and images on http://www.contesti.eu/opensource/xyz-dc-motor-controller

AVRCNC is a CNC-Controller based on an ATMega8 and some other (cheap) hardware. Main advantages compared to L297+L298 are: - simpler to build - easier to expand - mega8 controlls motors directly - no time-critical tasks on PC

piCNC is a PIC based stepper motor controller for use in CNC applications. Its software and hardware development is completely open source and community supported.