Search Results for "firmware"

A series of open source files and programs available to use for developing programs to work with the WowWee Robotics RSMedia Robot. These include a USB serial console, a cross-compiler, a firmware dump program, text-to-speech and source code.

...This code is for the direct-sampling input of the receiver, which transmits real samples over USB3 at up to 130 MHz sample rate. rx2fits processes these samples to spectral intensities via a Fourier-transform poly-phase filter bank, which provides spectral resolution approaching the spectral bin width with good stop-band and adjacent-channel rejection. Sample rate, Fourier bin count, PFB frame count, integration time and receiver gain parameters can be set. Utilities for device enumeration, firmware upload, display of FITS header, file viewing, and for measuring sample rate and sample statistics are provided. The device interface is Ruslan Migirow's librx888 and dropped samples at 130 MHz are negligible. Runs on linux computers under .Net.

What is it? It's a Bootloader for Microchip, Atmel, NXP, TI and 8051 devices. A Bootloader is a firmware running in the microcontroler device which allows the user to send it's own firmware without the need of a programmer. This Bootloader consists of: - firmwares for many devices (this firmware need to be send to the device's flash memory with a programmer, only once) - a PC software which communicates with the bootloader firmware in the device and send the user's program in its memory Where does it come from? ...

NEW VERSION 3.2.1.5 - MARS 2022 ECG Logger is a Wearable Cardio Monitor for Long-Term (up to 24h) ECG Data Acquisition and Analysis (aka Holter) with an ECG live (real-time) mode. The ECG Logger project is aimed for providing a very low-cost open-source "Hardware and Software" for a Cardiac Rhythmic Holter. The hardware has been made very simple and is based on an Arduino Nano micro-controller with two companion boards for the SD card mass-storage and the instrumentation differential...

Welcome to the my3D printer Tevo Tarantula site. Here you find find firmware, upgrades, modifications and new parts to make your Tevo Tarantula even better. Full users guide taking you from once assembled to printing. Step by step detailed instructions. Also see my 3D Projects site at https://sourceforge.net/projects/my-3d-projects

ASCOM driver for the LittleFoot Elegance Photo (LFEP) telescope controller. Firmware 6.x is fully supported - firmware 5.x is partially supported (all LFEP features are available but configuration is only possible by handbox). Contains drivers for telescope, focuser, camera, filter wheel, roof controller and dew heater which shares a single connection to the controller.

Graphical interactive windows application and library written in .Net/C# for simulating and controlling robots. Including firmware for ATmega8 to be controlled by the C# library and circuits for the ATmega8 controller board and L298-based motor board

Firmware for Digi's Connect Me .Net module for NCD boards. It support ProXR, Taralist, ProXR Lite and Reactor boards.