Search Results for "get"

...It was built to make research repeatable on accessible platforms—most notably low-cost mobile manipulators—while still scaling to richer hardware. The library exposes canonical abstractions (base, arm, gripper, camera, sensors) with calibration and kinematics helpers so beginners can get meaningful results quickly. It also plugs into simulation backends, letting you prototype perception and control algorithms before deploying on physical robots. By standardizing common operations and providing examples, PyRobot reduces boilerplate and encourages best practices in perception-control loops, data collection, and benchmarking.

The Dragon Fire compiler takes a new, 21st century, look at the Dragon (i.e. Dragon Book). No longer impenetrable to the programmer, this compiler is open and available to them. You control the Dragon, and get Dragon insight into your programs.

...Supports ASCII, RTU, TCP, and UDP transports as slave or master, automatic request partitioning and response data type parsing. For commercial licenses see www.InfiniteAutomation.com Get the most recent code here: https://github.com/infiniteautomation/modbus4j For support: http://infiniteautomation.com/forum/category/11/modbus4j-general-discussion

...Make sure you have git-lfs installed 2. Clone the repository: git clone git@github.com:auralius/libkine.git 3. Go to the directory of the cloned project, use git-lfs to get the binaries and the robot 3D models: git lfs checkout 4. Build the source using CMake 5. Create directory: mkdir build 6. Go inside build, type: cmake .. 7. Type: make 8. Run: ./demo1 or ./demo2 ../model/puma/puma.csv ../model/puma/puma.csv --- Binaries and robot 3D models are stored with git-lfs (https://git-lfs.github.com).