Search Results for "computer controller"

...A suitable MIDI controller would be either a MIDI keyboard, a guitar equipped with a MIDI pickup such as the Fishman triple play, or even an electric guitar pickup plugged into a computer audio interface running pitch-to-MIDI software.

This project experiments with C language to discover and design a programmable guitar amplifier effects micro controller computer section of a tube and solid state designed guitar amp. This a collaboration electronics project with my son. The goal of this project is to use Arduino hardware with C language programming to manipulate the guitar signal by various effects of phaser, flanger, reverb, digital delay and echo, and tremelo. Also, the signals of two microphones, two guitars, and one mp3 device will be inputted into and passed through two 3-band programmable equalizers. ...

...will send the corresponding USB keystroke to the host computer. You can program *any* USB Consumer Device control code too...for example, Play, Pause, Mute, Volume up, Volume down, and many others.

...Parrot advertises the toy as an advance in gaming because the control devices will project a virtual reality allowing users to play with their physical drone with an enhanced version on their controller where bullets or hot air balloons must be avoided in the virtual world. KIPR, KISS Institute for Practical Robotics is an organization that facilitates the learning of robotics programming in middle and high school students to peak an interest in computer science. To do this they hold competitions around the world called botball where students program autonomous land robots to perform various sets of tasks. ...

A robotic DIY styrofoam cutter consisting of one rotational and two translational axes. It cuts a variety of shapes out of styrofoam-like materials using a hot wire. This project documents the necessary hardware and software parts. Don't miss the follow-up project at http://raumschaum.org Its goal is to further develop hardware and software into an user friendly application.

AVRCNC is a CNC-Controller based on an ATMega8 and some other (cheap) hardware. Main advantages compared to L297+L298 are: - simpler to build - easier to expand - mega8 controlls motors directly - no time-critical tasks on PC