Search Results for "write serial" - Page 2

syphon is an extension for mod_openopc, to monitor telnet devices (serial devices) that sit on Serial -to- Ethernet bridges (such as barcode scanners) and export parsed data to an OPC compliant device (such as a PLC).

catty is a small utility to write+read to+from a serial tty device. You can use it in scripts, or directly writing some text to its stdin. With catty you can add in a few seconds serial communication to your shell scripts.

RedComm is a lightweight Java library. It simplifies communication over the serial port by providing methods and interfaces, which can be used to read and write to the serial port or over an emulated serial cable by using bluetooth. The major focus is on the ease of use of the library. Besides that the experienced user has the ability to change the reading and writing behaviour of the library. This means the user can easily extend and customize the RedComm library. ...

Introduction A Jailbroken Serial for iOS is an ObjectiveC wrapper for the UART interface, which is available on jailbroken iOS device. This wrapper provides basic read/write command set with various pre-defined baud rate. Also, it provides both sync and async communication for a 'read' command (attention: although async mode is very convienient, but it will hog the CPU time on your device!

NetFlash100 contains a full system image with a Linux kernel, root file system and the web interface to access flash memory of ATMEL ATNGW100 boards. To be able to use NetFlash100 you need: 1. ATNGW100 board with a working u-boot. 2. Ethernet and serial terminal connections. 3. A SD card (must be more than 40MB) Once you successfully boot NetFlash100 image, it provides you with a web interface on IP 10.0.0.1, with this interface one can read, write and erase the available flash devices on the system. It can also add, modify or delete u-boot parameters. NetFlash100 also provides information about the system and it's flash devices that might be useful. ...

A server that allows read and write access to serial port through TCP protocol.

this is a widget to integrate with QT Designer. You can communicate with the serial port without write any line of code.

EERPOM programming software for FTDI USB<=>Serial convertors configuration EEPROM. Can read/write/erase eeprom with ftdi convertor, save/load configuration file

Mprog is a tool designed for programming microcontroller. At the moment it supports only Atmel AVR microcontroller It support read / write programm flash / eeprom. To file firmat are supported: binary & Intel hex.

QCP Link is a small set of command line utilities which interact with Qualcomm Phones. We're starting with the QCP-2760 model. The utilities read the configuration/phonebook from the phone via the serial interface and write it to a file and vice versa.