Search Results for "pwm"

...Compatible with tone() library, see ReceiveDemo. Supports more platforms, since the new structure allows to easily add a new platform. Feedback LED also for sending. Ability to generate a non-PWM signal to just simulate an active low receiver signal for direct connection to existent receiving devices without using IR.

periph is a Go library that unifies hardware I/O on single-board computers and embedded Linux devices, exposing clean interfaces for GPIO, I²C, SPI, UART, PWM, and more. Its philosophy is “no daemon, no codegen”—you link a Go package and speak directly to the hardware via stable abstractions, keeping deployments simple and auditable. The project auto-detects host capabilities at runtime and selects the best driver backend, smoothing over kernel and board differences across Raspberry Pi, BeagleBone, and other platforms. ...

BlackLib library is wrote for controlling Beaglebone Black's feature. It takes power from C++ language. It is created for reading analog input, generating pwm signal, using gpio pins, and communicating with other devices over uart, spi and i2c. In addition to them, it includes debugging feature. So you can check errors after call any function in the library.

serialLCD is Arduino based open-source project. It contains ATmega8 with given firmware file & the arduino library. The ATmega8 can be replaced by ATmega168/328. ATmega8 uses its 8MHz internal oscillator to reduce hardware (atmega8 no-xtal bootloader is used). The arduino library uses SoftwareSerial internally to communicate ATmega8 via digital pin 6 (only for uno/duemilanove or clone with atmega8/168/328, not for mega & due). Only one wire simplex serial communication at baudrate 9600 is...