Search Results for "usb\unknown"

...UCM Kits can be assembled by hand with documentation at https://developers.enapter.com/docs/tutorial/ucm-kit/introduction **Setup** In order to upload firmware to development board over USB, you need to add your user to the `dialout` group. Open a terminal window, run the following command and *reboot* your computer. > `sudo usermod -a -G dialout $USER` Now restart your computer and you're good to go! **Are you having issues?** Contact with us in Discord: https://go.enapter.com/discord **Support our project** Put a ⭐ on Github: https://github.com/Enapter/marketplace

The IoT Leaf is a small ESP32-based device which can be used as highly flexible power supply, as embedded controller or as a combination of both: it consists of a board which can be cut into two pieces resulting in two different devices or which can be used as one. The board can be powered via solar cell or USB and provides a battery charging function and deep-discharge protection for LiPo batteries. Beside the ESP32 the microcontroller part is prepared for a LoRaWAN and a GPS module. Both together provide a powerful hardware which can be used in many different scenarios. Details and the full specification are available at https://iot.halaser.de This repository contains different firmware-examples and applications which can be used together with this board as well as hardware designs which are free to be used.

The C-GM Counter is a low cost (<50$) DIY Hardware & Firmware for building a Connected Geiger-Müller counter device to record beta-gamma radiation levels. The counter is the hardware part of the overall A-GM project aimed for providing a long-term continuous measurement of the radioactivity level. see also A-GM Manager at https://www.instructables.com/id/DIY-Radioactivity-Counter-IoT-and-Eco-system/ ** IMPORTANT ** : From v1.4, Arduino Nano require Optiboot bootloader to work, other...

imgFlasher has been built specifically for Embedded and IoT developers in order to flash OS images on SD cards and USB drives. Made primarily for Raspbian, Ubuntu, Debian, Yocto-based images but works with any kind of Linux distribution. imgFlasher is a portable software that doesn't require any installation. The process of flashing OS with imgFlasher is super simple and requires just 3 steps. (1) Choose img/zip file. (2) Choose drive to flash on

....- ESP8266 gets a firmware that allows the user to control it by serial port. Therefore it can be used along with any terminal, computer or microcontroller, which is equipped with a serial port (or USB port) -) Connect / disconnect to WiFi and Flespi MQTT broker -) Publish messages -) Subscribe to topics / Unsubscribe from topics -) Read the messages received Furthermore a GUI is on developing process to demonstrate the use. Paypal donations are welcome! reinharddaemon@gmail.com