Search Results for "it manager"

The C-GM Counter is a low cost (<50$) DIY Hardware & Firmware for building a Connected Geiger-Müller counter device to record beta-gamma radiation levels. The counter is the hardware part of the overall A-GM project aimed for providing a long-term continuous measurement of the radioactivity level. see also A-GM Manager at https://www.instructables.com/id/DIY-Radioactivity-Counter-IoT-and-Eco-system/ ** IMPORTANT ** : From v1.4, Arduino Nano require Optiboot bootloader to work, other boot crashes.

Broadlink Manager is a very simple way to work with broadlink rm products. when i just started working with Broadlink via Home Assistant i found out that teching the system a new code was not that simple and user friendly. so after searching the internet i found this little project written in c# that did wat i want, very easy way to work with broadlink.

...NodeManager is intended to take care on your behalf of all those common tasks a MySensors node has to accomplish, speeding up the development cycle of your projects an including the following main components: - Sleep manager: allows managing automatically the complexity behind battery-powered sensors spending most of their time sleeping - Power manager: allows powering on your sensors only while the node is awake - Battery manager: provides common functionalities to read and report the battery level - Remote configuration: allows configuring remotely the node without the need to have physical access to it - Built-in sensors: provide embedded code so to allow their configuration with a single line of common sensors Source code on http://github.com/mysensors/NodeManager

Iot device management, mqtt message storage and dashboards. Zibawa integrates other open source software to produce a full stack for IoT including device management, mqtt message interpreters, message enrichment, storage, dashboards and more. Zibawa integrates with rabbitmq,influxdb,grafana openldap to provide a secure end to end solution for IoT.