Search Results for "without code"

...The concept is to create the brain of your assistant by attaching an input signal (vocal order, scheduled event, MQTT message, GPIO event, etc..) to one or multiple actions called neurons. You can create your own Kalliope bot, by simply choosing and composing the existing neurons without writing any code. But, if you need a particular module, you can write it by yourself, add it to your project, and propose it to the community. Kalliope can run on all Linux Debian-based distributions including a Raspberry Pi and its multi-lang. The only thing you need is a microphone.

Espressif ESP32 Based Smarthome screen for MQTT. Control your MQTT/HomeKit Smart Home Devices from an ESP32-powered screen. Homepoint is a screen-based interface for MQTT & HomeKit-connected Smarthome devices that runs on the ESP32 Chipset. See partially switched-on scenes with multiple devices at a glance. Support for temperature, humidity, air quality sensors & Tasmota energy readings. Remote Configuration: Configure and reboot HomePoint through a web interface. No need to reflash....

Broadlink Manager is a very simple way to work with broadlink rm products. when i just started working with Broadlink via Home Assistant i found out that teching the system a new code was not that simple and user friendly. so after searching the internet i found this little project written in c# that did wat i want, very easy way to work with broadlink. but, my device type was new model and unsupported so i extended the support for all new models and added a feature wich allows me to add new device without using broadlink application.