Search Results for "btc flash software"

Betaflight is flight controller software (firmware) used to fly multi-rotor craft and fixed wing craft. This fork differs from Baseflight and Cleanflight in that it focuses on flight performance, leading-edge feature additions, and wide target support. Betaflight supports a wide range of flight controllers with at least an STM32F4 MCU. You can use nearly any piece of modern hardware out there. Full telemetry and high refresh rate for receivers, camera and VTX control, RGB LEDs, and much...

ESP8266 Arduino Core is the Arduino core for the ESP8266 WiFi chip. It brings support for the ESP8266 chip to the Arduino environment, allowing you to write sketches, use familiar Arduino functions and libraries, and run these directly on ESP8266 without the need for an external microcontroller. ESP8266 Arduino core comes with libraries that enable it to perform a number of things. It can communicate over WiFi through the use of TCP and UDP; it can set up HTTP, mDNS, SSDP, and DNS...

Since the summer of 2010, the FSAE team High Speed Karlsruhe uses Infineon's XC878 to power its electronics. The XC878 is an 8052 compatible 8-bit µC. Our dedication is to 8-bit real time applications, guaranteed by the powerful peripherals of the XC878. This project aims to publish those portions of our code, which may be of use to a wider audience.

Ddr-Z8E is a device driver library for the Zilog Z8 Encore!(r) microcontroller. The library supports I/O, IRQ, RS-232, I2C, SPI, A/D, WDT, ticker and built in flash memory as well as utility modules, e.g. for debugging and binary number representation.

The GDB (GNU debugger) RSP (remote serial protocol) allows remote debugging of embedded software. This project offers source code of monitors so the developer only needs to burn flash EPROMs once, then use serial communication to download/debug.