Search Results for "tau-analyzer-setup"

Alternative firmware for ESP8266 with easy configuration using webUI, OTA updates, automation using timers or rules, expandability and entirely local control over MQTT, HTTP, Serial or KNX. Unless your Tasmota powered device exhibits a problem or you need to make use of a feature that is not available in the Tasmota version currently installed on your device, leave your device alone - it works so don't make unnecessary changes! If the release version (i.e., the master branch) exhibits...

PK2Aux is a library and suite of command-line utilities for using the Microchip PICkit2 programmer device for purposes other than programming (such as the generic pin controls, serial UART, and logic analyzer modes provided by the Windows software).

Growlight facilitates management of all storage devices known to the Linux kernel, from hardware RAIDs to hybrid media to ramdisks to ZFS (indeed, Growlight was initially written to simplify ZFS on Linux). It understands the majority of partition and filesystem types, as well as both software and hardware RAID, LVM, and encrypted disks.

The SCSI Bus Analyzer Solution (scsitrace) is a Linux device driver that can be enabled on-the-fly to capture protocol traces trafficking across SCSI-based storage devices.

hidtouch is an input device driver supporting USB touchscreens that are not recognized by Linux as event devices but as regular HID devices. A few companion programs will ease the setup and calibration process.

HW(VHDL) and SW of logic analyzer and On-Chip-Verification(OCV) for Value Change Dump(VCD) file format that exported to seemd SystemC ,ModelSIM, and many other EDA tools. Very easy and Simple.

m4-la is a Logic Analyzer written in VHDL for the Xilinx ML403 Development board featuring the Virtex4 FPGA. The user interface is written in C for Windows32 based platforms. Xilinx ISE and EDK tools compile the VHDL and MS Visual Studio compiles the UI.

OpenTCA is C/C++-based software for the Linux/BSD platform, intended to allow anyone with a computerized-vehicle to analyze trouble codes without having to pay a mechanic to do it.

This software allows you to read HP4145 Semiconductor Parameter Analyzer files on a Linux PC.

CONECT is a software to design, setup, commission and test home and building-automation systems. It will support various bus systems such as EIB.

...The PID algorithm will insure that the motor will not get into hold vibrations if the pot has some influences. This article will describe where you have to take attentions and what you have to setup to get the best results. The project will help you to connect any arduino motor shield or other H-Bridges to the controller because it is open source and the output pins can therefor be changed as you like. You can upload a better modified version and improove this article by contacting me. With some pin changes you can port this code to other arduino boards.